Centrifugal Spray Dryer Case Study for Chemical Pigment Dye Catalyst Powder Production
Project Background
A specialty chemical manufacturer needed a dependable way to convert liquid slurries of pigments, dye intermediates and catalysts into a stable, free-flowing powder. The feed arrived as a pumpable suspension of fine solids in water, and the finished powder had to keep a precise particle size distribution, low residual moisture and consistent colour, because the product is judged by its performance in downstream inks, coatings and chemical formulations.
Customer Challenge
- The liquid feed was a solution, emulsion or suspension that had to be dried into solid powder or granules in a single pass.
- The active materials were heat sensitive and could not survive a long, hot residence time without losing colour or activity.
- The powder had to meet a precise standard for particle size and distribution, mass density and residual water content.
- The process had to avoid any crushing or sorting after drying in order to protect product purity.
Solution: High-Speed Centrifugal Spray Dryer
Our centrifugal spray dryer machine was selected for the duty. Air is filtered and heated before it enters the air distributor at the top of the dryer, where it spirals evenly into the drying chamber. The liquid feed is atomized into extremely fine droplets by a high-speed centrifugal atomizer at the top of the tower, and those droplets then come into contact with the hot air in a parallel flow.
Because the drying step is completed in only a few seconds, 95%-98% of the water is evaporated almost instantly, so the heat-sensitive chemical actives keep their colour and strength. The finished product is discharged continuously from the bottom of the drying tower, through a cyclone separator and a bag filter, while the exhaust gas is vented by an induced draft fan. The whole drying step is short, clean and enclosed, which keeps the finished powder high in purity.
Process Parameters
| Parameter | Specification |
|---|---|
| Feed form | Solution, emulsion, suspension or pumpable paste |
| Feed moisture content | 40%-60% (for special materials the content might be up to 90%) |
| Atomization | High-speed centrifugal atomizer at the top of the tower |
| Water evaporation | 95%-98% of the water can be evaporated at a moment |
| Drying time | Only several seconds |
| Powder collection | Cyclone separator and bag filter with continuous discharge |
| Post-drying treatment | No smashing and sorting required |
Results
- The finished powder showed good uniformity, flowability and solubility, and stayed high in purity and quality.
- Product particle diameters, looseness and water content could be adjusted through changing the operating condition within a certain range.
- Removing the crushing and sorting steps reduced the number of production procedures and further enhanced product purity.
- Operation and control of the whole line were simple and very convenient to manage.
Conclusion
By adopting the centrifugal spray dryer, the manufacturer dried sodium fluoride, pigments, dye intermediates, catalysts and precipitated silica into ready-to-ship powder in one continuous step. Where the particle size and distribution of the final product, residual water content, mass density and particle shape must meet a precise standard, this spray drying technology proved to be one of the most desirable options. For special requirements, the factory can provide consultation and design services to tailor the dryer to each chemical feed.
Contact Person: Mr. Zuo
Tel: +86 15051989720
Fax: 86--15051989720